This is the mail archive of the
gdb@sources.redhat.com
mailing list for the GDB project.
Re: GDB using Angel error on an OKI board
- From: Grant Edwards <grante at visi dot com>
- To: Charles-Henri Balet <charles-henri at bluewin dot ch>
- Cc: gdb at sources dot redhat dot com
- Date: Mon, 25 Feb 2002 13:17:36 -0600
- Subject: Re: GDB using Angel error on an OKI board
- References: <005801c1bd6a$b6545e10$0401a8c0@CHARLESHENRI> <20020225102723.A11481@visi.com> <000f01c1ebb8$84dbc630$0401a8c0@CHARLESHENRI>
On Wed, Apr 24, 2002 at 07:50:23PM +0200, Charles-Henri Balet wrote:
>>> I'm using an OKI developpement board with the OKI ML671000
>>> processor, this is provide with an ARM SDT 2.50 software and an
>>> ARM Angel 1.20 in the flash memory on the board
[...]
>>> (gdb) target rdi com1
>>> RDI_open: undefined error message, should reset target
>>> RDI_open failed
[...]
>> 1) Reset the board.
>> 2) Start GDB.
>> 3) Do the command "maint rdilogen on"
>> 4) Do the command "target rdi com1"
>> 5) Exit GDB
> tx: [T=0 L=36] 03 01 00 01 05 00 03 00 00 00 00 00 ff ff ff ff ff ff ff ff
> 01 00 00 00 00 c0 00 00 01 00 00 00 80 25 00 00
> R=00030005 H->T CI_HBOOT: ADP_ParamNegotiate 00000001 0000c000 00000001 00002580
> rx: [T=0 L=36] 03 02 01 01 05 00 03 80 00 00 00 00 ff ff ff ff ff ff ff ff
> 00 00 00 00 01 00 00 00 00 c0 00 00 80 25 00 00
> R=80030005 H<-T CI_HBOOT: ADP_ParamNegotiate 00000000 00000001 0000c000 00002580
> tx: [T=0 L=20] 03 02 00 01 06 00 03 00 00 00 00 00 ff ff ff ff ff ff ff ff
> R=00030006 H->T CI_HBOOT: ADP_LinkCheck
The link check stuff has caused problems for me in the past
with other ADP devices. Try doing a "set rdiheartbeat off"
before you do the "target" command.
--
Grant Edwards
grante@visi.com