This is the mail archive of the crossgcc@sources.redhat.com mailing list for the crossgcc project.

See the CrossGCC FAQ for lots more information.

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]
Other format:	[Raw text]

Re: Cross Tools Help

From: sridhar <nsridhar at igcar dot ernet dot in>
To: Bill Gatliff <bgat at billgatliff dot com>
Cc: Joel Sherrill <joel dot sherrill at OARcorp dot com>, crossgcc at sources dot redhat dot com
Date: Mon, 5 May 2003 12:14:01 -0500 (GMT)
Subject: Re: Cross Tools Help
>received: from localhost by eid.igcar.ernet.in (SMI-8.6/SMI-SVR4)id MAA21978; Mon, 5 May 2003 12:14:01 -0500

Dear Mr.Gatliff,

	When i build a m68k-elf cross tool chain, during configure step i
specify target=m68k-elf and the toolset is built for all families of m68k
like CPU's 68K, 68020, 68030, 68040, etc.

	If i want to build the toolset for a particular CPU only (say
68020), how do i do it?

Regards,

N.SRIDHAR
Electronics & Instrumentation Divn
Indira Gandhi Centre For Atomic Research (Dept. of Atomic Energy)
Kalpakkam - 603102 




------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sources.redhat.com

Follow-Ups:
- Re: Cross Tools Help
  - From: David Brown
- Re: Cross Tools Help
  - From: Bill Gatliff
- Re: Cross Tools Help
  - From: Aaron J. Grier

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]