This is the mail archive of the crossgcc@sourceware.cygnus.com mailing list for the crossgcc project.
See the CrossGCC FAQ for lots more infromation.
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |
Hi, The same error still occurs in spite of new downloads of both gcc-core and gcc-g++. I'm running cygwin 1.1.0 on NT. I have downloaded and succesfully installed eCos 1.3.1. The objective of this project is to run eCos on ARM AEB-1 evaluation board. I just can't figure out why this error occurs when making gcc. I attach my configure.out and make.out from the attempt to build gcc. /Andreas -----Original Message----- From: Richard Earnshaw [mailto:rearnsha@arm.com] Sent: den 27 juni 2000 15:52 To: Karlsson Andreas Cc: crossgcc@sourceware.cygnus.com; rearnsha@arm.com Subject: Re: Error in arm.h? > Hi, > I'm a student trying to build the eCos operating system but the following > error occurs when building gcc. > /src/gcc/gcc-2.95.2/gcc/config/arm/arm.h:226: parse error before `{' > /src/gcc/gcc-2.95.2/gcc/config/arm/arm.h:226: warning: unknown escape > sequence: `\' followed by char code 0xd > /src/gcc/gcc-2.95.2/gcc/config/arm/arm.h:227: warning: unknown escape > sequence: `\' followed by char code 0xd It looks to me as though MS-DOG has got hold of your source code. (0xd is the DOG return character). This is then confusing the pre-processor. You need to get a clean copy of the source. R. ------ Want more information? See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/ Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com
------ Want more information? See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/ Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |