This is the mail archive of the crossgcc@sourceware.cygnus.com mailing list for the crossgcc project.

See the CrossGCC FAQ for lots more infromation.

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]

Configure for ppc

To: crossgcc at sourceware dot cygnus dot com
Subject: Configure for ppc
From: Rickard Fahlquist <rifa at enea dot se>
Date: Thu, 13 Apr 2000 17:37:33 +0200

Hi,
I am trying to configure Gcc to crosscompile for PowerPC. The
configuration step gives me a hard time though. When I, from bash, try
to run the command:
$/source/binutils/configure --target=powerpc-eabi --prefix=/ppc860-eabi
-v
I get the reply:      bash: configure: command not found
This is despite the fact that the file "configure" is in the directory
/source/binutils
Can anyone tell me what mistake I am doing?
Thanks
Rickard Fahlquist


------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com

Follow-Ups:
- Re: Configure for ppc
  - From: Ola Liljedahl
- Re: Configure for ppc
  - From: Graham Stoney

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]