This is the mail archive of the crossgcc@sourceware.cygnus.com mailing list for the crossgcc project.

See the CrossGCC FAQ for lots more infromation.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]

Re: GCC cross compiler



Michael -

On Thu, 13 Apr 2000, Michael George wrote:

> can anyone please tell me how to install GCC as a cross compiler for
> a hitachi i-586 embedded processor in a lego RCX kit running cygwin
> under win95/98.  if you know can you tell me the cygwin command line to 
> configure the GCC files.

I am not sure from the note exactly which combination you need, but I was
able to build an 'sh-elf' toolset based on 'egcs' snapshots by following
the instructions for building the toolset for Cygnus/RedHat 'eCos' for the
SH-3. I had to install a recent Cygwin environment (I used B20.1) and the
pre-built gcc-2.95.2 for pc-cygwin. Check in
<http://sourceware.cygnus.com> and
<ftp://ftp.xraylith.wisc.edu/pub/khan/gnu-win32/cygwin/gcc-2.95.2/>

That setup will build Insight, too.

I am building under WinNT, and don't know about the requirements of
other MSWin environments.

   John Mills
   Sr. Software Engineer
   TGA Technologies, Inc.
   100 Pinnacle Way, Suite 140
   Norcross, GA 30071-3633
   e-mail: jmills@tga.com
   Phone: 770-441-2100 ext.124 (voice)
          770-449-7740 (FAX)


------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]