This is the mail archive of the mailing list for the GDB project.

Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]

RE: Questions on GDB

Hi Pete,

For a remote PPC target (through rproxy), I use:
 file xyz.elf
 target remote ip.addr:port

It's really cool that you ported the Macraigor DLL to Linux!  I
think more people would use the Wiggler if your port was made
available :-).


> -----Original Message-----
> From: Peter Reilley []
> Sent: Thursday, June 01, 2000 2:24 PM
> To:
> Subject: Questions on GDB
> I have a few questions on the operation of GDB with the Wiggler
> and a PowerPC target.
> I have ported the Macraigor DLL from MS Windows to Linux and
> am attempting to get GDB working.   I can read and write registers
> and memory in the PPC target.   I have a small test program that
> I compiled with GCC configured as a cross compiler for the PPC.
> I can use the "load" command and have the binary load properly
> in the target memory.   I can use the "symbol-file" command to
> load the symbols.   The "file" command will load the binary but
> it seems to have a base address in the host and not the target.
> The "run" and "step" commands do not seem to work.
> Anyway, what are the commands that you used to load and execute
> a binary in a target under Windows.   The documentation that I found
> on the internet is conflicting.
> Thanks,
> Pete.

Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]