This is the mail archive of the
gdb-patches@sourceware.org
mailing list for the GDB project.
Re: [RFA] Don't ignore consecutive breakpoints.
On Monday 26 November 2007 21:39:21 Michael Snyder wrote:
> On Fri, 2007-11-23 at 23:10 +0300, Vladimir Prus wrote:
> > Suppose we have two breakpoints at two consecutive
> > addresses, and we do "step" while stopped on the
> > first breakpoint. GDB testsuite has a test (consecutive.exp)
> > that the second breakpoint will be hit a reported, and the
>
> Yeah, I was the author of that test, back in 2001.
> Several years and several employers ago, but I think
> I am able to remember a little about the context.
>
> > test passes, but the code directly contradicts, saying:
> >
> > /* Don't even think about breakpoints if just proceeded over a
> > breakpoint. */
> > if (stop_signal == TARGET_SIGNAL_TRAP && trap_expected)
> > {
> > if (debug_infrun)
> > fprintf_unfiltered (gdb_stdlog, "infrun: trap expected\n");
> > bpstat_clear (&stop_bpstat);
> > }
> >
> > what's happening is that we indeed ignore the breakpoint, and try
> > to step further. However ecs->another_trap is not set, so we step
> > with breakpoints inserted, and immediately hit the now-inserted
> > breakpoint. Therefore, I propose to remove that code.
> >
> > On x86, the below patch causes a single test outcome change:
> >
> > -KFAIL: gdb.base/watchpoint.exp: next after watch x (PRMS: gdb/38)
> > +PASS: gdb.base/watchpoint.exp: next after watch x
>
> Yeah, the problem is that you have only tested x86 architecture,
> and what I think I recall is that this test was for software
> single-step.
>
> You have to be aware that you have just single-stepped, so that
> you interpret the trap instruction under the PC as related to
> stepping. If you have two consecutive BP-related traps, and you
> try to single step over one of them, you may miss the second one
> because you believe it to be only a single-stepping trap.
>
> Can you test your patch on an architecture that uses software SS?
I've tested on arm-linux/qemu, which uses software single-step,
and got no regressions.
Looking again at the patch, the code fragment I'm changing has
two side-effects:
- Setting ecs->random_signal
- Setting stop_bpstat
My patch has no effect on the way ecs->random_signal is set.
However, in the case when we've just single-stepped over
breakpoint, the original code will clear stop_bpstat, and in
my patch, it would be set. We will immediately report report
the hit of the consecutive breakpoint. Since we don't set
ecs->another_trap, the trap_expected variable will be reset
to 0 when we resume.
So, is the patch OK?
- Volodya
- Volodya