This is the mail archive of the mailing list for the GDB project.

Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]
Other format: [Raw text]

[RFA] remove unwanted output in breakpoint_re_set_one

The patch below finally removes the 
lot of "Watchpoint XXXX" or "Hardware watchpoint XXX" output that can be seen
both for normal and hardware watchpoints 
at each loadnig of a shared library (or each DLL
in win32 target.

This problem was first reported in my first proposal
about win32 hardware watchpoint support for win32 target,
and caused some confusion, as this was first seen as a
problem with my implementation.
But this was a quite general error present for other targets, like i386 linux,
see my post-scriptum in

The call to mention at that location in breakpoint_re_set_one 
seems completely unnecessary.

2002-01-14  Pierre Muller  <>

	* breakpoint.c (breakpoint_re_set_one): Remove call to mention
	for watchpoints to avoid unnecessary output 
	when dynamic libraries are loaded.

Index: breakpoint.c
RCS file: /cvs/src/src/gdb/breakpoint.c,v
retrieving revision 1.57
diff -u -p -r1.57 breakpoint.c
--- breakpoint.c        2001/11/11 16:39:59     1.57
+++ breakpoint.c        2002/01/14 11:19:54
@@ -7139,8 +7139,6 @@ breakpoint_re_set_one (PTR bint)
             xfree (b->cond);
           b->cond = parse_exp_1 (&s, (struct block *) 0, 0);
-      if (b->enable_state == bp_enabled)
-       mention (b);
        value_free_to_mark (mark);
      case bp_catch_catch:

Pierre Muller
Institut Charles Sadron
6,rue Boussingault
Phone : (33)-3-88-41-40-07  Fax : (33)-3-88-41-40-99

Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]