Re: crosstool configure exits with gcc error.

["Yann E. MORIN" <yann dot morin dot 1998 at free dot fr>]

John, All,

On Tuesday 10 July 2012 05:07:40 Home wrote:
> I am new to cross toolchain development.   I amusing building_embedded_linux_systems
> as a guide book to help me get started.  there is a discussion on crosstool, and some
> examples i thought i would try.
> after downloading and unpacking the croostool-ng package i run the configure command.
> >configure --prefix=/my_directory
> .. it does several things but then errors out when it does the gcc check.
> the config.log shows me:
> -it found gcc version 4.1.2
> -it then attempted gcc conftest.c and failed due to assembler problems. the specific errors 
> are something like this 'Error: suffix or operand invalid for push'
> 
> i am hoping this is an obvious problem.  any suggestions are greatly appreciated.
> i am running on an i686 pc linux machne.

Can you cut-n-paste the full ./configure log?

Regards,
Yann E. MORIN.

-- 
.-----------------.--------------------.------------------.--------------------.
|  Yann E. MORIN  | Real-Time Embedded | /"\ ASCII RIBBON | Erics' conspiracy: |
| +33 662 376 056 | Software  Designer | \ / CAMPAIGN     |  ___               |
| +33 223 225 172 `------------.-------:  X  AGAINST      |  \e/  There is no  |
| http://ymorin.is-a-geek.org/ | _/*\_ | / \ HTML MAIL    |   v   conspiracy.  |
'------------------------------^-------^------------------^--------------------'

--
For unsubscribe information see http://sourceware.org/lists.html#faq