This is the mail archive of the
binutils@sourceware.org
mailing list for the binutils project.
Account for .tbss alignment when adjusting start of relro
- From: Alan Modra <amodra at gmail dot com>
- To: binutils at sourceware dot org
- Date: Thu, 19 Nov 2015 16:32:13 +1030
- Subject: Account for .tbss alignment when adjusting start of relro
- Authentication-results: sourceware.org; auth=none
Another option might be to not bump "dot" for .tbss alignment in the
main section sizing loop, but that could leak some of the following
section into the TLS segment. Leakage shouldn't matter since it will
be to bytes past the end of .tdata, but for now this is a safer
option.
PR ld/19264
* ldlang.c (lang_size_sections): Don't ignore .tbss when
adjusting start of relro region.
diff --git a/ld/ldlang.c b/ld/ldlang.c
index 3841afc..c45b912 100644
--- a/ld/ldlang.c
+++ b/ld/ldlang.c
@@ -5457,18 +5457,23 @@ lang_size_sections (bfd_boolean *relax, bfd_boolean check_regions)
/* For sections in the relro segment.. */
for (sec = link_info.output_bfd->section_last; sec; sec = sec->prev)
- if (!IGNORE_SECTION (sec)
+ if ((sec->flags & SEC_ALLOC) != 0
&& sec->vma >= expld.dataseg.base
&& sec->vma < expld.dataseg.relro_end - expld.dataseg.relro_offset)
{
/* Where do we want to put this section so that it ends as
desired? */
- bfd_vma start = sec->vma;
- bfd_vma end = start + sec->size;
- bfd_vma bump = desired_end - end;
+ bfd_vma start, end, bump;
+
+ end = start = sec->vma;
+ if ((sec->flags & SEC_HAS_CONTENTS) != 0
+ || (sec->flags & SEC_THREAD_LOCAL) == 0)
+ end += sec->size;
+ bump = desired_end - end;
/* We'd like to increase START by BUMP, but we must heed
alignment so the increase might be less than optimum. */
- start += bump & ~(((bfd_vma) 1 << sec->alignment_power) - 1);
+ start += bump;
+ start &= ~(((bfd_vma) 1 << sec->alignment_power) - 1);
/* This is now the desired end for the previous section. */
desired_end = start;
}
--
Alan Modra
Australia Development Lab, IBM