Next: save tracepoints, Previous: tfind, Up: Analyze Collected Data [Contents][Index]
tdumpThis command takes no arguments. It prints all the data collected at the current trace snapshot.
(gdb) trace 444 (gdb) actions Enter actions for tracepoint #2, one per line: > collect $regs, $locals, $args, gdb_long_test > end (gdb) tstart (gdb) tfind line 444 #0 gdb_test (p1=0x11, p2=0x22, p3=0x33, p4=0x44, p5=0x55, p6=0x66) at gdb_test.c:444 444 printp( "%s: arguments = 0x%X 0x%X 0x%X 0x%X 0x%X 0x%X\n", ) (gdb) tdump Data collected at tracepoint 2, trace frame 1: d0 0xc4aa0085 -995491707 d1 0x18 24 d2 0x80 128 d3 0x33 51 d4 0x71aea3d 119204413 d5 0x22 34 d6 0xe0 224 d7 0x380035 3670069 a0 0x19e24a 1696330 a1 0x3000668 50333288 a2 0x100 256 a3 0x322000 3284992 a4 0x3000698 50333336 a5 0x1ad3cc 1758156 fp 0x30bf3c 0x30bf3c sp 0x30bf34 0x30bf34 ps 0x0 0 pc 0x20b2c8 0x20b2c8 fpcontrol 0x0 0 fpstatus 0x0 0 fpiaddr 0x0 0 p = 0x20e5b4 "gdb-test" p1 = (void *) 0x11 p2 = (void *) 0x22 p3 = (void *) 0x33 p4 = (void *) 0x44 p5 = (void *) 0x55 p6 = (void *) 0x66 gdb_long_test = 17 '\021' (gdb)
tdump works by scanning the tracepoint’s current collection
actions and printing the value of each expression listed. So
tdump can fail, if after a run, you change the tracepoint’s
actions to mention variables that were not collected during the run.
Also, for tracepoints with while-stepping loops, tdump
uses the collected value of $pc to distinguish between trace
frames that were collected at the tracepoint hit, and frames that were
collected while stepping. This allows it to correctly choose whether
to display the basic list of collections, or the collections from the
body of the while-stepping loop. However, if $pc was not collected,
then tdump will always attempt to dump using the basic collection
list, and may fail if a while-stepping frame does not include all the
same data that is collected at the tracepoint hit.
Next: save tracepoints, Previous: tfind, Up: Analyze Collected Data [Contents][Index]