Next: Register Names, Up: Assembler Syntax [Contents][Index]
See the Xtensa Instruction Set Architecture (ISA) Reference Manual for a complete list of opcodes and descriptions of their semantics.
If an opcode name is prefixed with an underscore character (‘_’),
as will not transform that instruction in any way. The
underscore prefix disables both optimization (see Xtensa Optimizations) and relaxation (see Xtensa Relaxation) for that particular instruction. Only
use the underscore prefix when it is essential to select the exact
opcode produced by the assembler. Using this feature unnecessarily
makes the code less efficient by disabling assembler optimization and
less flexible by disabling relaxation.
Note that this special handling of underscore prefixes only applies to
Xtensa opcodes, not to either built-in macros or user-defined macros.
When an underscore prefix is used with a macro (e.g.,
refers to a different macro. The assembler generally provides built-in
macros both with and without the underscore prefix, where the underscore
versions behave as if the underscore carries through to the instructions
in the macros. For example,
_MOV may expand to
The underscore prefix only applies to individual instructions, not to
series of instructions. For example, if a series of instructions have
underscore prefixes, the assembler will not transform the individual
instructions, but it may insert other instructions between them (e.g.,
to align a
LOOP instruction). To prevent the assembler from
modifying a series of instructions as a whole, use the
no-transform directive. See transform.