This is the mail archive of the insight@sources.redhat.com mailing list for the Insight project.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]
Other format: [Raw text]

RE: Building Insight snapshot on CygWin?


# From: Keith Seitz [mailto:keiths@redhat.com]
# Sent: Tuesday, May 27, 2003 12:36 PM
# To: Schumacher, Gordon
# Cc: Insight list (E-mail)
# Subject: RE: Building Insight snapshot on CygWin?
# 
# I don't see any of this. Does libtcl84.a not contain this symbol? What
# does "head config.status" say? Can you do a "make clean; make 
# > make.out
# 2>&1" and send make.out?

Sorry about the delay in replying; I was out for all of last week.

So, I tried snapshot 20030602, and that one builds fine (with dejagnu nuked)
even as a CygWin to i686-pc-msdosdjgpp cross-debugger.  But, now I've got
problems getting it to run properly...

About 90% of the time, option buttons and checkboxes don't change state upon
being clicked.  They highlight - but the check doesn't change.  Option
buttons usually contain *neither* setting.
I can connect to an application via Remote/Serial, but when it hits a
breakpoint, the main window says only "Select a function to disassemble".  I
can pick a source file, but I can't seem to get it to indicate where it is
stopped at (i.e., no "you are here" highlight.)  Single-stepping does
nothing; continue and "step asm" commands seem to do *something* but without
knowing where the PC is there's not much use to that.

Would it be helpful to try a Linux to DJGPP cross-debugger and see if that
works?  I'm not quite sure where to even start looking on this one...!

My cross-binutils package is version 2.13.2, FWIW.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]