This is the mail archive of the
gdb@sourceware.org
mailing list for the GDB project.
Re: GDB stub question?
This means your stub is capable of doing single stepping by itself. S12
would mean give signal 12 to the debuggee.
>From the manual ->
`S'SIG`;'ADDR -- step with signal
Like `C' but step not continue.
If you need more help show a complete log of the remote protocol for the
steps you did and the behaviour you expected / observed.
- Ramana
On Mon, 2006-04-24 at 11:43 +0530, Inder wrote:
> Hi All
>
> I have ported a GDB stub for ARM based system, but when i tried doing
> source stepping GDB (GDB 6.4) host sends the following packet to the
> target system:
>
> ---> $S12#b6
>
> which tell the target to actually do a single instruction step. I
> believe in the previous versions of GDB source stepping was done by
> setting the breakpoint to the next source line and then continue.
>
> Am i missing something here.
>
> Any help will be appriciated.
>
> --
> Thanks,
> Inder