This is the mail archive of the
gdb-patches@sourceware.org
mailing list for the GDB project.
Re: [PATCH 1/2] Bump to autoconf 2.69 and automake 1.15.1
- From: Alan Modra <amodra at gmail dot com>
- To: Nick Clifton <nickc at redhat dot com>
- Cc: Simon Marchi <simon dot marchi at polymtl dot ca>, gdb-patches at sourceware dot org, binutils at sourceware dot org, Simon Marchi <simon dot marchi at ericsson dot com>
- Date: Sat, 16 Jun 2018 11:09:17 +0930
- Subject: Re: [PATCH 1/2] Bump to autoconf 2.69 and automake 1.15.1
- References: <20180615004309.29913-1-simon.marchi@polymtl.ca> <df0ee0e1-8e97-ffb6-edb2-c0aee39b262f@redhat.com>
On Fri, Jun 15, 2018 at 03:22:10PM +0100, Nick Clifton wrote:
> Otherwise so far, my testing has been showing no signs of any real problems.
The patch looks good to me too. I did see some generated file
differences, most of which disappeared when I compiled my own
autoconf-2.69 rather than using the Ubuntu 18.04 version (which
apparently has some patches from autoconf-2.70 applied).
I applied both of your posted patches, ran autoconf in zlib since
you'd said the posted patch was broken, touched all the files in the
first patch, then built binutils-gdb with --enable-maintainer-mode.
Apart from .pot files, these were the files that differed:
bfd/doc/Makefile.in
binutils/doc/Makefile.in
gas/doc/Makefile.in
gdb/aclocal.m4
gdb/config.in
gdb/configure
gdb/gnulib/aclocal.m4
gdb/gnulib/configure
libdecnumber/aclocal.m4
zlib/configure
--
Alan Modra
Australia Development Lab, IBM