[PATCH] Fix register selection in var-access.exp

[Andreas Arnez <arnez at linux dot vnet dot ibm dot com>]

The new test var-access.exp causes FAILs on i686.  This is because the
test chooses the wrong name for DWARF register number 1: It uses
"edx" (which corresponds to DWARF register number 2), but should have used
"ecx" instead.

Also, the current logic in var-access.exp does not correctly distinguish
between a 64-bit and a 32-bit program on an x86-64 target.  It uses the
64-bit register names for both.

These problems are fixed.  In order to address the latter, the convenience
macros is_*_target are exploited where appropriate.

gdb/testsuite/ChangeLog:

	* gdb.dwarf2/var-access.exp: Use register name ecx instead of edx
	on 32-bit x86 targets.  Exploit is_*_target macros where
	appropriate.
---
 gdb/testsuite/gdb.dwarf2/var-access.exp | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/gdb/testsuite/gdb.dwarf2/var-access.exp b/gdb/testsuite/gdb.dwarf2/var-access.exp
index 157a96c..96c54e7 100644
--- a/gdb/testsuite/gdb.dwarf2/var-access.exp
+++ b/gdb/testsuite/gdb.dwarf2/var-access.exp
@@ -28,16 +28,16 @@ if {![dwarf2_support]} {
 
 set dwarf_regnum {0 1}
 
-if { [istarget "aarch64*-*-*"] } {
+if { [is_aarch64_target] } {
     set regname {x0 x1}
-} elseif { [istarget "arm*-*-*"]
+} elseif { [is_aarch32_target]
 	   || [istarget "s390*-*-*" ]
 	   || [istarget "powerpc*-*-*"]
 	   || [istarget "rs6000*-*-aix*"] } {
     set regname {r0 r1}
-} elseif { [istarget "i?86-*-*"] } {
-    set regname {eax edx}
-} elseif { [istarget "x86_64-*-*"] } {
+} elseif { [is_x86_like_target] } {
+    set regname {eax ecx}
+} elseif { [is_amd64_regs_target] } {
     set regname {rax rdx}
 } else {
     verbose "Skipping tests for accessing DWARF-described variables."
-- 
2.5.0