This is the mail archive of the
gdb-patches@sources.redhat.com
mailing list for the GDB project.
Re: [patch/rfc] Use frame_type for sigtramp test in infrun.c
- From: Ulrich Weigand <weigand at i1 dot informatik dot uni-erlangen dot de>
- To: cagney at gnu dot org
- Cc: gdb-patches at sources dot redhat dot com
- Date: Tue, 30 Mar 2004 01:38:35 +0200 (CEST)
- Subject: Re: [patch/rfc] Use frame_type for sigtramp test in infrun.c
Andrew Cagney wrote:
> * infrun.c (handle_inferior_event): For non legacy frames, use the
> frame ID and frame type to identify a signal trampoline. Update
> comments.
This breaks signals.exp on s390 again.
What now happens is the following:
- we are in main and do 'next'; step_frame_id is set to the current frame
- gdb starts single-stepping
- in the meantime, a signal has arrived and the kernel invokes the handler
Note that the kernel directly jumps to the handler, and sets up the
return address to point to the signal return trampoline.
- gdb single-steps and stops on the first instruction of the handler
at this point, the call-chain is
handler
<signal trampoline>
main
- gdb thinks it has stepped into a subroutine, and does
handle_step_into_function, which calls keep_going
- keep_going saves the current pc (i.e. start of handler) into prev_pc
- we run until the return from handler, i.e. we stop on the first
(and only) instruction of the signal trampoline
- now the 'if' you changed hits because we are in fact in a signal trampoline
frame.
- within the if, there's a second if that tries to distiguish between
stepping into a trampoline before the signal handler from one after
the signal handler. This is attempted via
if (frame_id_inner (current_frame, step_frame_id))
- unfortunately, step_frame_id is still the frame of 'main', and thus
the current (i.e. trampoline) frame *is* 'inner', even though we
actually have a trampoline after, not before the handler.
- gdb now does
sr_sal.line = 0;
sr_sal.pc = prev_pc;
/* We could probably be setting the frame to
step_frame_id; I don't think anyone thought to try it. */
check_for_old_step_resume_breakpoint ();
step_resume_breakpoint =
set_momentary_breakpoint (sr_sal, null_frame_id, bp_step_resume);
However, prev_pc was set to first instruction of handler above
- since we never again enter the handler, the breakpoint is never hit
and we run until the end of main
I'm not sure what the correct way to fix this issue would be.
However, simply removing the whole 'if' block makes signals.exp pass on s390.
This is because both the handler and the signal return trampoline are now
simply treated as calls into subroutines, and both are skipped with
step_over_function, so that everything works just as expected.
Why is this if needed in the first place? Isn't this just to work around
frame problems that caused step_over_function to not handle signal handlers
correctly? I.e. if we have new-style frames that work properly, can't we
just skip that whole if?
Bye,
Ulrich
--
Dr. Ulrich Weigand
weigand@informatik.uni-erlangen.de