This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
Re: printf and diag_printf go to nowhere
Robert Brusa wrote:
This little serial example program. Compiled, linked downloaded with
BDI all ok. But I can not start it with BDI/telnet go 0. Hell and
death - just before I did just this!
Are you sure that execution is supposed to start at address 0x0 ? If
it's a ROM application, try go 0x00100000 (I believe that's the starting
point for your target).
Also, another thing that might confuse you is the configuration script
for BDI. It will set up the target CPU to a state that is different than
the one you get without the BDI. When I write applications that are
supposed to start up the board (ROM startup type), I use a stripped down
version of the config file, that will not touch the configuration
registers in the CPU.
However, when disconnecting BDI and switching power on, the program
launches and works correctly. Putting the JTAG connector back into its
place, reseting the BDI via telnet, I can now start the program using
go 0. But only once. etc. In short, it seemed to be unstable and I
gave in switched everything off and went home.
This looks like the configuration script kicking in :)
Regards,
Edgar
--
Edgar Grimberg
System Developer
Zylin AS
Phone: (+47) 51 63 25 00
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss