Re: [ECOS] LPC2106 iar kickstart eval board port

[Alexandre <thekyz at gmail dot com>]

Thx a lot i'll try that at work.
So the .elf i obtain from the arm-elf-objcopy command isn't good ?
What do i have to do to make the actual file i'll upload to my board ?

On 6/13/07, Andrew Lunn <andrew@lunn.ch> wrote:
> On Wed, Jun 13, 2007 at 05:44:00PM +0200, Alexandre wrote:
> > Well i tried to use the minimal and default settings.
> > I need thread management, serial drivers, and basic i/o management.
> > I use the command : arm-elf-objcopy -O ihex file.elf file.hex to make
> > my footprint.
>
> ihex is an ASCII format of "binary", so you cannot just look at the
> file size.
>
> A much better way to get an idea of the footprint is arm-elf-size.
>
> lunn@londo:~/eCos/work$ ecosconfig new at91sam7xek minimalU CYGHWR_HAL_ARM_AT91SAM7, new inferred value at91sam7x256
> U CYGHWR_HAL_ARM_AT91, new inferred value AT91SAM7S
> U CYGHWR_HAL_ARM_AT91_FIQ, new inferred value 1
> lunn@londo:~/eCos/work$ ecosconfig tree
> lunn@londo:~/eCos/work$ make -s
> headers finished
> build finished
> lunn@londo:~/eCos/work$ make -s tests
> headers finished
> build finished
> tests finished
> lunn@londo:~/eCos/work$ arm-elf-size install/tests/hal/common/current/tests/basic
>    text    data     bss     dec     hex filename
>   10630     552   33180   44362    ad4a install/tests/hal/common/current/tests/basic
>
> So here there is a little over 10K of code in the text segment and 0.5K
> of data. The bss, which goes in RAM is just under 33K.
>
>    Andrew

--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss