This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Cannot communicate with RedBoot on Viper board
- From: Paul Randall <prandall at delta-info dot com>
- To: ecos-discuss at sources dot redhat dot com
- Date: Tue, 05 Mar 2002 11:43:12 -0500
- Subject: [ECOS] Cannot communicate with RedBoot on Viper board
Hi All,
I just purchased a A&M Viper board and I am having trouble communicating
with RedBoot.
I am connected to Serial Port 2 (SMC1) on the Viper and I'm using
Windows 98 HyperTerminal to communicate with the board. I'm running
with the data rate set to 38400 bits per second, 8 data bits, no parity,
and one stop bit as instructed by the RedBoot documentation. I have
flow control turned off. A&M tech support told me I should see a '+'
when RedBoot starts up, but I don't get any response at all. A&M has
assured me that RedBoot was installed on my board.
When I plug in the Viper, green LEDs D3 and D4 both light up as does LED
D7. A&M support suggested I press the reset switches and look for the
'+' but all that happens is LED D8 turns on for a fraction of a second
before LED D7 turns back on.
Has anyone seen similar problems with the Viper? Any suggestions?
Paul Randall
Delta Information Systems
--
Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
and search the list archive: http://sources.redhat.com/ml/ecos-discuss