This is the mail archive of the ecos-devel@sourceware.org mailing list for the eCos project.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]
Other format: [Raw text]

strucking up in infinite loop for IXP 425


Hi,

              we are porting  ecos for ixp425 we have flashed the image as
per the sugessition in the forum but we are running in the infinite loop at
this point

icache_boundary:
        // Here is where we switch from boot address (0x000000000) to the
        // actual flash runtime address. We align to cache boundary so we
        // execute from cache during the switchover. Cachelines are 8 words.
        str     r1, [r2, #IXP425_EXP_CNFG0]    // make the EXP bus switch
        nop
        nop
        nop
        nop
   ----> mov     pc, r0
        nop

  where the instruction says pc value to load into r0 is at the same
location and it goes into infinite loop and never stops execution
  
                                  if i change the pc to ignore the step mov
pc,r0 then the code is allowing single stepping but the instruction is not
getting effected
 
can any one help out to sort this problem.


thanks & regards,
Sumanth
--
View this message in context: http://www.nabble.com/strucking-up-in-infinite-loop-for-IXP-425-t1198324.html#a3161071
Sent from the Sourceware - ecos-devel forum at Nabble.com.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]