This is the mail archive of the crossgcc@sources.redhat.com mailing list for the crossgcc project.

See the CrossGCC FAQ for lots more information.

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]

Re: Cross compile error question: i686 to powerpc--linux-gnu

To: David Korn <dkorn at pixelpower dot com>
Subject: Re: Cross compile error question: i686 to powerpc--linux-gnu
From: Joe Sislow <flynn at cosmodog dot com>
Date: Wed, 17 Oct 2001 11:34:34 -0500
CC: crossgcc at sourceware dot cygnus dot com
Organization: Cosmodog, Ltd.
References: <718D38CAB6E0D011B2C90060970C28A57E198A@exchangeserver.pixelpower.com>
Reply-To: flynn at cosmodog dot com

David Korn wrote:

> >-----Original Message-----
> >From: Joe Sislow [mailto:flynn@cosmodog.com]
> >Sent: 17 October 2001 16:59
>
> >    TARGET=powerpc--linux-gnu
>
>   I've never seen anyone else put two dashes there and I could easily
> picture that screwing up the crude pattern-matching used in the config
> scripts to analyze the target-triples.
>

I'm not 100%, but I believe that it's ok.  I figure that I would have
choked FAR eariler than this phase if there had been a problem with
that.  However, the argument should have three parts.  If you believe
that my syntax is incorrect, what should it be?

powerpc-linux-gnu?

Thanks for the quick response, BTW.

------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com

References:
- RE: Cross compile error question: i686 to powerpc--linux-gnu
  - From: David Korn

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]