Instruction prefixes are used to modify the following instruction. They are used to repeat string instructions, to provide section overrides, to perform bus lock operations, and to change operand and address sizes. (Most instructions that normally operate on 32-bit operands will use 16-bit operands if the instruction has an “operand size” prefix.) Instruction prefixes are best written on the same line as the instruction they act upon. For example, the ‘scas’ (scan string) instruction is repeated with:
repne scas %es:(%edi),%al
You may also place prefixes on the lines immediately preceding the
instruction, but this circumvents checks that
with prefixes, and will not work with all prefixes.
Here is a list of instruction prefixes:
.code16section) into 32-bit operands/addresses. These prefixes must appear on the same line of code as the instruction they modify. For example, in a 16-bit
.code16section, you might write:
addr32 jmpl *(%ebx)
64) used to change operand size from 32-bit to 64-bit and X, Y and Z extensions bits used to extend the register set.
You may write the ‘rex’ prefixes directly. The ‘rex64xyz’
instruction emits ‘rex’ prefix with all the bits set. By omitting
z you may write other
prefixes as well. Normally, there is no need to write the prefixes
explicitly, since gas will automatically generate them based on the