Next: , Up: Xtensa-Dependent


9.42.1 Command Line Options

The Xtensa version of the gnu assembler supports these special options:

--text-section-literals | --no-text-section-literals
Control the treatment of literal pools. The default is `--no-text-section-literals', which places literals in separate sections in the output file. This allows the literal pool to be placed in a data RAM/ROM. With `--text-section-literals', the literals are interspersed in the text section in order to keep them as close as possible to their references. This may be necessary for large assembly files, where the literals would otherwise be out of range of the L32R instructions in the text section. These options only affect literals referenced via PC-relative L32R instructions; literals for absolute mode L32R instructions are handled separately. See literal.
--absolute-literals | --no-absolute-literals
Indicate to the assembler whether L32R instructions use absolute or PC-relative addressing. If the processor includes the absolute addressing option, the default is to use absolute L32R relocations. Otherwise, only the PC-relative L32R relocations can be used.
--target-align | --no-target-align
Enable or disable automatic alignment to reduce branch penalties at some expense in code size. See Automatic Instruction Alignment. This optimization is enabled by default. Note that the assembler will always align instructions like LOOP that have fixed alignment requirements.
--longcalls | --no-longcalls
Enable or disable transformation of call instructions to allow calls across a greater range of addresses. See Function Call Relaxation. This option should be used when call targets can potentially be out of range. It may degrade both code size and performance, but the linker can generally optimize away the unnecessary overhead when a call ends up within range. The default is `--no-longcalls'.
--transform | --no-transform
Enable or disable all assembler transformations of Xtensa instructions, including both relaxation and optimization. The default is `--transform'; `--no-transform' should only be used in the rare cases when the instructions must be exactly as specified in the assembly source. Using `--no-transform' causes out of range instruction operands to be errors.
--rename-section oldname=newname
Rename the oldname section to newname. This option can be used multiple times to rename multiple sections.